There’s no need to employ a professional fitter so the overall cost of your new flooring is very economical. Peel & stick vinyl floor tiles are easy to fit yourself. But, hey, you don’t have any glue on you, none on me.Nordic Oak Self-Adhesive Vinyl Floor Tile Because, like I said earlier, that notched trowel, and the glue just gets all over you. John: I have not, but I have the confidence to get some of these other rooms done.ĭanny Lipford: It’s pretty easy, because without that glue process, installing vinyl like this is a heck of a lot easier. Have you tried any, have you installed any floors at all before? Went down a lot easier than I ever imagined putting a floor down.ĭanny Lipford: Yeah. Well, John, one of the things, a big advantage of this, you don’t have to wait for any of the glue to dry before you can get in here with your drop cloth and go ahead and paint this room out. A few cinder blocks will hold them in place until they dry. John’s planning to replace the floors in the adjacent rooms soon, so we’re just gluing these in place to avoid putting any nail holes in the flooring where it will be seen. Cutting around the doorways takes a little more time, but is still pretty easy if you have a nice, sharp utility knife. Then it’s a matter of cutting the sheet to fit the two remaining walls by folding it at the baseboard and cutting it in the fold. With two walls set, we can peel off the backing on the tape and hold the flooring in position on those walls. The tape goes around all the walls to avoid any shifting while we’re working. Let’s go ahead, and we’ll put this down without peeling the backing off of it. But the other side supposedly has the ability, if you mess up a little bit you can peel it. One side of this tape sticks to the floors, really aggressive. We roll it back up in the opposite direction so that we can roll it out face up back in the room. At about $2.75 cents a square foot, this stuff is pretty affordable, especially if you’re installing it yourself. Outside, we roll the flooring out facedown on the drive, so that we can make our rough cuts. We want to reuse the shoe mold so we’re being very careful not to break it. While it dries, we remove the shoe molding around the perimeter of the room. The floor patch will fill in the low places, so that we don’t feel any depressions under the new vinyl. John Richards: Yeah, we had a water heater incident which flooded this room.ĭanny Lipford: We’ll have to just take a putty knife and get the most of that out and we can just floor-patch that and go right over all of this. And now we got a few places here we’ll have to patch. We’ll add a few inches to our measurements for doorways, but otherwise this is pretty straightforward, since the room is almost square. And if you’ll hold that right over there, against the wall actually. Well, this material ought to go down pretty well. And it’s a flexible sheet flooring with a fiberglass backing that’s much thicker than traditional sheet vinyl so that it can be installed either with or without adhesive. The product is called AirStep Evolution from Congoleum. But what if you could install a vinyl floor on the same principle that you have here on a laminate floor, where it basically just floats in place without any adhesive? That would be great and that’s exactly what we did recently in helping a friend of mine install a brand new product.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |